NOTE: It might be easier to just define Z_PROBE_PIN to something other than -1, which is what it is defaulting to, as set in configuration.h: In that case check board description and use the digital pin number instead for that function. You are using ORIG_FAN2_PIN in your configuration but apparently your boards pin definition does not define that pin. This error:įastio.h:29: error: 'DIOORIG_FAN2_PIN_WPORT' was not declared in this scope but these seem to be more to do with selecting the correct board, #define MOTHERBOARD, in pins.h, than the disabling of the Z-probe. However, thereafter, upon recompilation, I then get a lot of other errors. If not, then in configuration.h set the FEATURE_Z_PROBE to false, like this:Īs this requires the FEATURE_Z_PROBE if otherwise set to 1 or true. "You, obviously, do actually have a Z-probe, but in case another user does not, or you decide not to use yours, I will cover both cases (with and without a Z-probe). Also, there is a T0 on the additional board which is connected to A13 of the main controller." The X-min and Z-min are connected to the X-min and Z-min on the additional green board respectively. Hope this helps.Įdit2: The Y-min pin on the main controller board is empty. Please note that this is v1.1 and my printer has v1.3 although I haven't found any difference between the two, yet. On the web these printers are known as "D-force printers".Įdit1: I found this on the manufacturer's Facebook group: Here is a close-up of the Z-probe & the servo motor that pins it down.Īny help would be appreciated here. I'm unable to do so because it's not plugged into the main board. Now, while compiling the firmware, I need to specify the Z-probe pin. It can be found here, Repetier-Firmware. I've downloaded a new firmware from Repetier website. I haven't been able to find the other green board (with the HRD12008 SMPS on it), yet. I've traced the printer down to a Taiwanese manufacturer: D-FORCE.TW - 3D Printer. The brand on all these boards is "D-force". The other box with an acrylic top is a solid state relay. The other green board beside it has a DC to DC SMPS (HRD12008) on it, along with Z-min, X-min, T0, Fan-, D11 and a flat ribbon wire connector (can be seen in the picture).
These are the controller boards of my printer:
"Building new Repetier firmware for a delta printer (D-force) So my printer's calibration got screwed after a sudden reboot and since the current firmware (0.92.6) is licensed, I cannot edit it.
0 kommentar(er)
